General Purpose Probes
54-400-019 with a 90° conical diamond stylus, .0004" (10µm) radius per ANSI-B46, ISO, and MIL specs.54-400-026 with a 90° conical diamond stylus, .0002" (5µm) radius per DIN-4768 and certain ISO specs. |
 |
Parallel Chisel Probe (Optional)
54-420-002 with a 90° sapphire chisel, .0004" (10µm) radius. Gages sharp edges or small OD's where probe is perpendicular (in 90° or 270° position) to axis of traverse. Also for OD's smaller that .25" (6.35mm) staged on 54-400-421 Vee fixture. |
 |
Traverse Chisel Probe (Optional)
54-420-001 with a 90° sapphire chisel, .0004" (10µm) radius. Gages sharp edges or small OD's where probe is aligned with (in 180° or closed position) axis of traverse. |
 |
Groove Bottom Probe (Optional)
54-420-028 with a 90° conical diamond stylus, .0004" (10µm)
radius. Gages grooves, recesses and holes to depths of .25"
(6.35mm). Also used for short lands and shoulders. (Groove Bottom
Probes can only be used in the 180° position with the Pocket Surf,
supported in the height stand or a similar fixture.)
Small Bore Probes (Optional)
54-420-021 with a 90° conical diamond stylus, .0004" (10µm) radius.
54-420-027 with a 90° conical diamond stylus, .0002" (5µm) radius.
Gages small bores (1/8 (3.2mm) min. I.D.) up to a depth of 3/4" (19mm).
(Small Bore Probes can only be used in the 180° position with the Pocket Surf,
supported in the height stand or a similar fixture.)
|
